M308 S1 P"spi.cs1" Y"rtd-max31865" A"e0_heat" T"k" F60 ; create sensor number 1 as a PT100 sensor in the first position on the Duet 2 daughter board connector Flipped drive gears – filament path closer to the extruder center for a more balanced design and perfect fit on delta printers as well

M574 Z1 S1 P"zstop+e1stop" ; configure active-high endstops for low end on Z via pins zstop and e1stop New motor design offers ~40% increase in pushing force in real printing conditions and much improved acceleration performance vs the -36sth20-0504 There are now two hex pattern inlays based on the design by 3DP-MAMSIH and a tutorial on how to apply them to the shroud. The negative body feature of Prusa/Super Slicer can also be used to create a crop-top version of the shroud as described at the end of the tutorial. I recommend using a file to lightly remove any printing artifacts on the mating face of the shroud.Before I reached this solution, I have tried many sensor types and sensing methods, in the end this is the final solution I considered most suitable for this purpose. We are pleased to be carrying the LDO Oribiter 2.0 by Dr. Lorincz Rober, and produced by LDO Motors. Carefully push the status LED carrier as far as it will go and press the fan into position while making sure not to pinch the part-cooling fan wires. Then press the remaining LEDs into their slots. (I measure out 35mm of wire to connect these LEDs together) E3D Hemera takes a totally new approach to 3D printer extruders. It combines an extruder and a hot-end in a single unit. This approach means you can make the combo more compact and achieve a shorter filament path between the extruder and the hot-end. The filament path is also all metal which makes it better at pushing flexibles and abrasives.

I have added new stretched versions that should fit the Rapido UHF, Dragon UHF and the VolcoMosq hotends. The Dragon UHF and Rapido UHF hotends can fit in the same shroud. The UHF hotends will reduce Z travel by 8.5mm and the VolcoMosq by 3mm. I cannot verify the fitment so if there are any issues please leave a comment. The position of the motor has been rotated by 10 degrees to facilitate its maintenance and installation The PEEK gear sleeve has been revised and is now made of a hard and more mechanically resistant materialFlipped drive gears – filament path closer to the extruder center for a more balanced design and perfect G0 E-70 F300 ; continue extraction slow allow filament to be cooled enough before reaches the gears

My Voron 2.4 running Klipper had been running great for a while but the afterburner assembly was starting to show weakness. I thought it was a good time for an upgrade so I installed a new Orbiter 2.0 with filament detector on my Voron 2.4 and the problems began...... pressure_advance_smooth_time : 0.03 ## E0 on MOTOR6 ## Make sure to update below for your relevant driver (2208 or 2209) [ tmc2209 extruder ] A new extruder can significantly improve your print quality and speed. If you are still running a BMG extruder you should know there are better options out there. Popular extrudersM92 Z1600 ; Leadscrew motor axis steps/mm for Z - TR8*2 / 1.8 deg stepper or TR8*4 / 0.9 deg stepper This makes the gcode independent of the filament diameter, potentially allowing the same gcode to run on different printers. P - Sensor type - 1=simple sensor (high signal when filament present), 5= Duet Laser v2.0, 6= Duet Laser v2.0 with microswitch